Roof Replacement & Repairs
Call248-326-2020
roofing army logo
CallText
Homeowner Guide

Pole Barn and Outbuilding Metal Roofing in Michigan

By Aaron Scott|9 min read|

Most Michigan pole barns, machine sheds and outbuildings get an exposed-fastener steel panel, barn metal, screwed straight to purlins with no plywood decking underneath. We install JB Ultra 2000, a 29-gauge Galvalume panel rated for 130 mph wind and Class 4 hail with a 45-year limited finish warranty, cut to length up to 50 feet so most barns get one panel from ridge to eave. Written by Aaron Scott, licensed Michigan residential builder and owner of Roofing Army, which installs barn metal, standing seam and Tilcor steel on both houses and the barns beside them.

What Kind of Metal Roof Goes on a Michigan Pole Barn?

Almost every pole barn, machine shed and agricultural outbuilding we quote gets the same answer: barn metal, an exposed-fastener steel panel screwed directly through its face into the purlins below, with a sealing washer under every screw. We run JB Ultra 2000, a 29-gauge Galvalume steel panel with a Ceram-A-Star siliconized polyester finish, rated for 130 mph wind and Class 4 hail, carrying a 45-year limited finish warranty from Jensen Bridge on top of our own 50-year workmanship warranty. The panel is cut to length up to 50 feet, so on most barns one sheet runs the full slope from ridge to eave with no horizontal lap for water to work into.

That is a different system than what goes on the house itself. Our Tilcor stone-coated steel shingles hide every fastener and are built to look like asphalt, and our standing seam panels, 24-gauge with a Kynar finish, hide their fasteners in a clipped seam and carry a 140 mph wind rating. Both cost more per square than barn metal, which is exactly why they go on houses, porches and accent roofs while barn metal goes on the structure that does not need to look like anything but a barn. We cover that full system-by-system breakdown, including the roughly 50 percent cost gap between standing seam and exposed fastener panels, in our standing seam vs exposed fastener guide.

Roof Replacement in Lake Orion, Michigan by Roofing Army
Roof Replacement in Lake Orion, MI · 2,646 sq.ft · $16,405.48See every job we publish

Why Purlins Change How We Reroof a Pole Barn

A pole barn is framed differently than a stick-built garage, and that changes the job before a single panel goes down. Most are built with purlins run directly across the trusses, with no plywood or OSB decking underneath, and the original steel was screwed straight to those purlins. When we reroof one, we check the purlin spacing against the new panel's rib pattern and inspect the purlins themselves for rot, rust bleed-through at old fastener holes, or any sag before new steel goes back on, since a post-frame roof's purlin spacing was engineered around a specific snow load. Adding plywood sheathing that was not part of the original design adds real dead weight the structure may not have been built to carry, which is why we check the numbers with the building department rather than bolt on decking as an assumed upgrade. We walk through the same structural logic for garages and sheds in our garage, shed and pole barn roofing guide, which also covers why a pole barn is priced on its own rather than folded into a per-square-foot garage range.

Barn Metal vs Standing Seam vs Tilcor Steel Shingles: Which Belongs on a Pole Barn?

We quote all three metal systems, and for a true pole barn or outbuilding, exposed fastener barn metal wins almost every time on cost and practicality:

Barn metal (JB Ultra 2000)Standing seamTilcor steel shingles
Best fitBarns, machine sheds, outbuildingsHouses, porches, accent roofsHouses
The panel29-gauge Galvalume, cut to length up to 50 ft24-gauge steel, formed to lengthStone-coated steel, 20 per square
FastenersExposed screws through the face, with washersHidden clips inside the seamScrews hidden under the next panel
Wind rating130 mph140 mph150+ mph
Hail ratingClass 4Class 4Class 4
Expected life45+ years50+ years75+ years
Material warranty45-year limited (Jensen Bridge)Finish warranty, 35 to 40 years typicalLifetime limited
Over one layer of the old roofFull tear-off, alwaysYes, when soundYes, when sound
Our workmanship warranty50 years50 years50 years

Barn metal always gets a full tear-off, even over a single old layer, unlike Tilcor or standing seam on a house roof that is otherwise sound; see our metal roof over shingles guide for why that distinction exists by system. We occasionally get asked to put standing seam on a pole barn for the cleaner look, and once in a while a homeowner wants barn metal on the house to save money; we will quote either, but we talk most people out of mismatching system to structure, since the cost and appearance tradeoffs run opposite to what the building actually needs.

Roof Replacement in Macomb, Michigan by Roofing Army
Roof Replacement in Macomb, MI · 3,362 sq.ft · $16,500.00See every job we publish

Do You Need a Permit to Reroof a Pole Barn in Michigan?

It depends on what the building is actually used for. Michigan's Stille-DeRossett-Hale Single State Construction Code Act exempts agricultural buildings, structures used to store farm products, equipment, or livestock, from the state construction code's definition of a "building," which the Michigan Farm Bureau cites as exempting a true farm building from the state's building permit requirement entirely. That exemption is narrow: it covers storage and agricultural use, not a pole barn that has been converted into a garage, workshop, man cave, or anything with a non-farm use, and your township or county can still require a zoning permit even when the building permit itself is exempt. A growing number of Michigan counties also expect the property owner to confirm the exemption in writing before work starts, and if it turns out the exemption did not actually apply, the building can be required to get a permit after the fact.

For the pole barns we roof on rural residential properties, out in Lapeer County, Metamora, Addison Township and similar communities, most are used alongside a house rather than for commercial farming, so we treat them like any other accessory structure and check with the local building department rather than assume an exemption applies. Our Michigan roof permit guide covers how that enforcement is delegated city by city for the house itself.

Does Condensation Matter on a Pole Barn Roof?

It can, more than most homeowners expect. A bare steel panel screwed directly to purlins with nothing between it and the inside of the building will sweat on the underside on humid summer mornings and on cold nights when warm, moist air rises off stored equipment, hay, or livestock and hits cold steel, the same dew-point mechanism that causes condensation on a cold glass. On an open pole barn that just means some dripping; on one used to store anything that rust or rot can damage, it is a real problem. Where the structure allows for it, we run the same high-temperature-rated underlayment we install under standing seam roofs between the purlins and the new panels, rather than screwing steel straight to bare wood, which gives condensation somewhere to drain instead of dripping straight down. It will not fully replace proper ventilation at the ridge and eaves, which matters as much on a pole barn as it does on a house, but it is a real difference between a barn re-roofed with no plan for moisture and one we actually think through.

Roof Replacement in Berkley, Michigan by Roofing Army
Roof Replacement in Berkley, MI · 1,567 sq.ft · $13,968.47See every job we publish

How Much Does It Cost to Reroof a Pole Barn in Michigan?

We do not publish a single range for pole barns the way we do for a one-car or two-car detached garage, since barn sizes vary too widely for one number to mean anything; a 30-by-40 machine shed and a 60-by-120 pole barn are not the same job, and we explain why in our garage, shed and pole barn roofing guide. What we can say honestly is the relative cost position: exposed fastener barn metal is the least expensive metal roofing system we install, since 29-gauge steel and a faster, simpler install run meaningfully cheaper than standing seam's 24-gauge panels and clipped seams. Manufacturer McElroy Metal, which sells both panel types, states that concealed-fastener systems like standing seam generally run about 50 percent more than a comparable exposed fastener system, a gap driven by both the heavier gauge and the slower install, covered in more depth in our metal roof cost guide. The only way to get a real number for your own structure is to have it measured, which is also true for the house next to it.

Get a Quote for Your Pole Barn or Outbuilding Roof

We roof pole barns, machine sheds and outbuildings alongside the main house across our rural service areas, and we get calls for this every week from homeowners whose current barn roof has started leaking or rusting at the screw lines and who cannot find a roofer willing to take on a structure that is not a standard house. Our inspections are free, we do not take deposits, and we give every customer several quotes at different price points, whether that is barn metal on the outbuilding alone or a combined quote for the house and everything behind it. See real pricing on roofs we have already installed in our job gallery, and start with our roof replacement page for the full list of systems we install, from asphalt shingles to standing seam metal to barn metal. We serve Southeast and West Michigan from offices in Oxford, Ferndale, Rochester Hills, Plymouth and Jenison.

Frequently Asked Questions

What is the best roofing material for a pole barn in Michigan?

Exposed fastener barn metal is the standard choice for pole barns, machine sheds and outbuildings. We install JB Ultra 2000, a 29-gauge Galvalume steel panel cut to length up to 50 feet, rated for 130 mph wind and Class 4 hail, with a 45-year limited finish warranty from Jensen Bridge and our own 50-year workmanship warranty on the install.

Can you put a new metal roof over the old one on a pole barn?

No. Unlike Tilcor stone-coated steel or standing seam on a house, which can often go over one sound layer of shingles, barn metal always gets a full tear-off, even over a single existing layer. That lets us check the purlins underneath for rot or rust before new panels go down, which matters more on an open-purlin structure with no plywood decking to hide problems.

Do I need a permit to reroof a pole barn in Michigan?

Only if the building does not qualify for Michigan's agricultural building exemption. The state's Construction Code Act exempts true farm buildings used to store crops, equipment or livestock from the building permit requirement, but that exemption does not cover a pole barn converted into a garage, workshop or living space, and local zoning rules can still apply either way. We check with the local building department rather than assume an exemption applies.

How much does it cost to reroof a pole barn in Michigan?

We do not publish one range, since pole barn sizes vary too widely for a single number to be useful; a small machine shed and a large pole barn are not comparable jobs. What we can say is that exposed fastener barn metal is the least expensive metal roofing system we install, running roughly half the installed cost of standing seam according to manufacturer McElroy Metal's own published comparison, since it uses lighter 29-gauge steel and a faster install.

How long does a barn metal roof last in Michigan?

JB Ultra 2000 carries a 45-year limited finish warranty and an expected service life of 45-plus years, with a Class 4 hail rating and a 130 mph wind rating. That is shorter than our standing seam (50-plus years) and Tilcor steel shingle (75-plus years) systems, but barn metal is also the lowest-cost option, which is why it remains the standard choice for a structure that does not need a 75-year roof over a stored tractor.

About the Author

Aaron Scott, Owner, Licensed Residential Builder

20+ years in the home service industry. Licensed residential builder in Michigan. Owner of Roofing Army with offices in Oxford, Ferndale, Rochester Hills, Plymouth, and Jenison.

Work With Michigan's Top Roofing Company

Get a free in-home quote.